-
After-sales Service
-
Contact Us
Malaysia Terminal automatic bending machine
Category:
MalaysiaLaser/automation equipment
Key words: Likai CNC
Product Description
Product features：
1. Take the nut mechanically：
(1) The nut-taking device adopts jaw cylinder structure, which is stable and reliable.；
(2) The structure is equipped with a detection sensor to detect whether the reclaiming and discharging positions are correct, otherwise the sensor will be turned on and an alarm will be raised; .
2. Double-station bending：
(1) The product adopts a double-station configuration in the bending process, which improves production efficiency.；
(2) One product is placed in each station, and the bending is stable and reliable.
3. Safety monitoring：
(1) The work area is equipped with safety gratings to prevent personal injury during work.；
(2) The product placement has directional position requirements, and the discharge detection sensor and direction sensor are configured to avoid incorrect product placement, resulting in the appearance of scrap products.
Product parameters：
|
Item |
Parameter |
|
Applicable products |
IGBT（Can be customized according to specifications） |
|
Nut machine |
Standard M5 nut machine (optional) |
|
efficiency |
4PCS/minutes |
|
Equipment shape |
1000×800×1700mm |
|
Air source |
≥0.8MPa（φ10mm interface） |
|
Power supply |
AC220V、50Hz |
|
Total power |
≤650W |
Product packaging process：
1. Manually place the module on both sides of the station, and add the right amount of nuts to the nut machine.；
2. After jog “Start (right)”, the product will go to the nut position 1. After it is in place, the nut shaft will start to pick and place the nuts, and then complete the three nut placement operations of this station in turn.；
3. After clicking “Start (left)”, the product will go to the nut position 2. After it is in place, repeat the previous step of picking and placing the nut operation.；
4. After the nut is placed, the products from the left and right stations will go to the tablet pressing process on both sides, and then reach the tablet pressing station 1, tablet pressing station 2, and tablet pressing station 3, and complete the tablet pressing operation on the corresponding station.；
5. After the tableting is completed, the module returns to the initial discharge position, the automatic operation light goes out, and the process ends.
Product Message
CX153A type multi-wire cutting equipment is mainly used for straight cutting of hard and brittle materials such as rare earth permanent magnets, quartz crystals, optical glass, precious metals, etc. The five-roller design can realize two functions: slicing and prescribing.
DF300/600 multi-wire cutting equipment is mainly used for slicing and processing of hard and brittle materials such as rare earth permanent magnets, optical glass, quartz crystals, etc. This equipment has the advantages of reliable function, high processing dimensional accuracy, and good product surface quality.
DA400 multi-wire cutting equipment is designed for the batch processing of super-hard and brittle materials such as sapphire, special ceramics, silicon nitride, etc. into straight pieces.The equipment is designed for a double-station design, and the cutting of super-hard and brittle materials is realized through the swing of the workpiece (reducing the cutting area).
Address: No. 7, Taipei South Road, Yantai Area, Pilot Free Trade Zone of China (Shandong)
Free Trade Zone
Contact: Mr. Wang
Contact Phone: +86-18753569015
Landline: +86-535-2133055
Fax: +86-535-2133155
Mailbox: likaikeji@ytlikai.com
